top of page

How to properly take your room measurements

Mar 17, 2023

Every buildable plan starts with one thing: real measurements.

Most measurement mistakes are small, and that's exactly why they're dangerous. They hide in the numbers you send us, and they only show up when something is already built — or already ordered.


The usual ones:


- Measuring the skirting board instead of the wall — the numbers look right and the plan is wrong by a centimetre on every side.


- Letting the tape sag or run at an angle. A tape that isn't flat against the wall and level adds centimetres that aren't there.


- Guessing where the window sits instead of measuring it. "About a metre from the corner" is not a measurement.


- Assuming the room is square. Most aren't, and a plan drawn square for a room that isn't will never fit.


- Measuring once. One number, no check, no second opinion — if it's wrong, nothing catches it.


Two checks catch almost all of it before you send anything. First: every window and door gets three numbers — corner to edge, width, edge to corner — and the three have to add up to the full wall. If they don't, you know you made a mistake while you can still fix it. Second: the two diagonals, corner to corner. If they differ by more than 2 cm, the room isn't square, and we need both numbers, not one forced to match.


A few things that help: measure each wall at floor level, with the tape flat against the wall; measure the ceiling height in two places, because ceilings are rarely level; note which way each door swings and what it hits; and write every number on the sketch the moment you measure it — never from memory, never later.


You need a tape measure, a pencil, and about ten minutes. Measure twice, send us the sketch with your AI image, and we'll take it from there.





bottom of page